Table of Contents
Advertisement
Usage
Perform steps (1) to (8) in order.
The product includes a 42BLF BLDC motor manufactured by ACT motor.
A motor must be a Hall sensor BLDC type for normal working.
Step
Check the R/B exterior, set switch correctly as described in 6.
(1)
Connect the motor to the board. (see 5)
(2)
Connect the stabilized power supply to MCD board.
(3)
Check the motor control switch. Set the start switch to "H". Set the brake
(4)
switch to "H". Set the OVP switch as desired. ("L": square wave, "H": sine
wave). Set the CW/CCW switch as desired rotation direction. ("L": CW, "H":
CCW)
Supply power and check if the power LED is ON.
(5)
Set the start switch to "L" to start rotating the motor.
(6)
Tune potentiometer to change a motor rotation speed.
(7)
Check how motor rotation speed changes by monitoring Test point "HP".
Set the start switch to "H" to stop rotating the motor.
(8)
If an Error Occurs
Power supply LED no "lighting": Check power supply cable and voltage.
‒
Motor no rotation: Check motor connection and Motor Control switch set.
‒
© 2019
Toshiba Electronic Devices & Storage Corporation
Table 8-1 Usage for MCD + Op-Amp mode
26 / 31
Item
RD022-RGUIDE-01-E
2019-Jan-15
Rev.1.0
Advertisement
Table of Contents
