Toro Greensmaster 04358 Operator's Manual page 16

Figure 13
1. Traction pedal
2. Brake pedal
Figure 14
Brake Pedal
Press the brake pedal
by actuating the drum-type brake located at each
traction wheel.
Parking-Brake Tab
To set the parking brake, press the brake pedal, then
press the parking-brake tab
the brakes. Disengage the tab by pressing the brake
pedal. Engage the parking brake before you leave
the machine.
Throttle Lever
The throttle lever (Figure
speed of the engine. Moving the throttle lever toward
the F position increases the engine speed; moving
AST
the throttle lever toward the S
the engine speed, but does not shut off the engine.
3. Parking-brake tab
(Figure 13) to stop the machine
(Figure 13) to engage
15) allows you to control the
position decreases
LOW
1. Throttle lever
g032580
2. Choke lever
3. Light-switch position
Choke Lever
To start a cold engine, close the carburetor choke
by pushing the choke lever forward
the C position. After the engine starts, regulate
LOSED
the choke lever to keep the engine running smoothly.
As soon as possible, open the choke by pulling the
lever rearward to the O
requires little or no choking.
g032581 Leak-Detector Test Switch
Use the switch
the leak detector alarm and time delay.
Hour Meter
The hour meter
the machine has operated. It starts to function
whenever you rotate the key switch to the O
Seat-Adjustment Lever
This lever, on the left side of the seat
allows you to adjust the seat 10 cm (4 inch) forward
and rearward.
1. Seat-adjustment lever
16
Figure 15
4. Leak-detector test switch
5. Hour meter
(Figure
position. A warm engine
PEN
(Figure 15) to check the operation of
(Figure 15) indicates the total hours
Figure 16
g032582
15) to
position.
N
(Figure 16),
g005503