•
Lift cylinders (3)
(Figure
•
Traction pedal
(Figure
•
Speed-selector linkage
32)
Figure 32
33)
Figure 33
(Figure 34
and
Figure
Figure 34
g005123
To grease the machine, complete the following
procedure:
1.
Wipe the grease fitting clean so foreign matter
cannot be forced into the bearing or bushing.
2.
Pump grease into the bearing or bushing until
the grease is visible. Wipe up excess grease.
3.
Apply grease to the reel motor spline shaft and
onto the lift arm when the cutting unit is removed
for service.
4.
Apply a few drops of SAE 30 engine oil or spray
lubricant (WD 40) to all pivot points daily after
cleaning.
g032715
35)
g005514
30
Figure 35
g017145