To Charge The Battery - Husqvarna Automower 310 Operator's Manual

4.7.1 Example 1
This example is applicable to products with a
specified work area of 500 m
the same for the other models.
Timer setting, Period 1: 00:00 - 00:00
Active period (A): 00:00 - 18:00
The timer setting ensures that the product begins
cutting the lawn at 00:00. However the product is
parked in standby mode in the charging station
from 18:00 and rests until it starts cutting again at
00:00.
Example: A specified work area of 500 m
Operation, A = max. hours
Charging/Standby, B = min. hours
4.7.2 Example 2
This example is applicable to products with a
specified work area of 500 m
the same for the other models.
The timer settings can be divided into 2 work
periods to prevent mowing when there usually is
other activities ongoing. If the timer setting is
divided into 2 work periods, the minimum standby
period must in total be according to the Standby
Timer and Standby on page
time table. Refer to
35 .
Timer setting Period 1 (A): 00:00
Timer setting Period 2 (C): 20:00
Active period (A): 00:00
Active period (C): 20:00
36 - Operation
The product operates between and 16:00. It
starts again at but stops at 22:00 due to standby
mode until it starts again at .
2
, but the principle is

4.8 To charge the battery

When the product is new or has been stored for a
long period, the battery can be empty and needs
to be charged before starting. In the Main area
2
mode, the product automatically alternates
18
between mowing and charging.
6
2
, but the principle is
1.
2.
3.
4.
Example: A specified work area of 500 m
Operation, A + C = max. hours
Charging/Standby, B + D = min. hours 6
WARNING: Only charge the product
using a charging station and a power
supply which is intended for it.
Incorrect use may result in electric
shock, overheating or leakage of
corrosive liquid from the battery.
In the event of leakage of electrolyte
flush with water and seek medical help
if it comes in contact with the eyes etc.
Set the Main switch to position
Place the product in the charging station.
Open the hatch and slide the product in as
far as possible to ensure proper contact
between the product and the charging
station.
The display shows a message that charging
is in progress.
2
18
1 .
1220 - 001 -