Information Messages - Husqvarna Automower 310 Operator's Manual

6.3 Information messages

Below a number of information messages are listed which may be shown in the product display.
Contact your local Husqvarna representative if the same message appears often.
Message Cause
Low battery
The product cannot find the charging
station.
The guide wire is broken or not connec-
ted.
The battery is spent.
The charging station's antenna is de-
fective.
Settings restored
Confirmation that a
tings has been carried out.
Guide not found
The guide wire is not connected to the
charging station.
Break in the guide wire.
The guide wire is not connected to the
boundary loop.
Guide calibration
The product has failed to calibrate the
failed guide wire.
Guide calibration
The product has succeeded to calibrate
accomplished
the guide wire.
Difficult finding
The product has been following the
home
boundary wire several laps without find-
ing the charging station.
46 - Troubleshooting
Action
Check that the charging station and the
guide wire are installed in accordance
with the instructions. Refer to
the guide wire on page 22 .
Find out where the break is and rectify
it.
Replace the battery. Refer to
on page 39 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 47 .
Reset all user set-
This is normal. No action required.
Check that the guide wire's connector
is tightly connected to the charging sta-
tion. Refer to
on page 22 .
Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Check that the guide wire is connected
correctly to the boundary loop. Refer to
To install the guide wire on page 22 .
Check that the guide wires are installed
according to the instructions. Refer to
To install the guide wire on page 22 .
No action required.
The installation has not been done cor-
rectly. Refer to
put the boundary wire on page 17 .
Wrong corridor width setting on boun-
dary wire. Refer to
width of the boundary wire on page 19 .
The product was started on a Secon-
dary area with the Main area setting.
To install
Battery
To install the guide wire
To examine where to
To set the corridor
1220 - 001 -