Cisco ONS 15327 Procedure Manual page 30

Required Tools and Equipment
9.
10.
11.
12.
13.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
The ONS 15327 is intended for installation in restricted access areas. A restricted access area is
Warning
where access can only be gained by service personnel through the use of a special tool, lock, key, or
other means of security. A restricted access area is controlled by the authority responsible for the
location.
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
The ONS 15327 is designed to comply with GR-1089-CORE Type 2 and Type 4. Install and operate the
Note
ONS 15327 only in environments that do not expose wiring or cabling to the outside plant. Acceptable
applications include Central Office Environments (COEs), Electronic Equipment Enclosures (EEEs),
Controlled Environment Vaults (CEVs), huts, and Customer Premise Environments (CPEs).
Note The Cisco ONS 15327 is intended for use with telecommunications equipment only.
Required Tools and Equipment
You will need the following tools and equipment to install and test the ONS 15327.
lncluded Materials
These materials are shipped with the ONS 15327. The number in parentheses provides the quantity of
the item included in the package.
•
•
•
•
Cisco ONS 15327 Procedure Guide, R4.0
1-2
NTP-B115 Preprovision a Slot, page
empty card slot with a card that will be installed later.
NTP-B8 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections, page
this procedure to install cables for alarms, timing, and LAN connections.
NTP-B220 Install the Electrical Cables, page
cables that will carry electrical traffic.
NTP-B221 Install Optical Cables, page
that will carry optical traffic.
NTP-B13 Perform the Shelf Installation Acceptance Test, page
determine if you have correctly completed all other procedures in the chapter.
#12-24 x 1/2 pan head Phillips mounting screws (4)
#10-32 x 3/8 pan head Phillips power lug screws (2)
#12 AWG dual hole 5/8 in. spaced grounding lug
Electrostatic discharge (ESD) wrist strap with 1.8 m (6 ft.) coil cable
1-28—As needed, complete this procedure to preprovision any
1-33—Complete this procedure to connect and route
1-40—Complete this procedure to connect and route cables
Chapter 1 Install Hardware
1-28—Complete
1-48—Complete this procedure to
March 2003