Chapter 13
Add and Remove Nodes
Figure 13-3 Circuits on Span Dialog Box with a Force Switch
Note
Return to your originating procedure (NTP).
Step 6
DLP-B198 Clear a Path Protection Switch
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Right-click the span where you want to clear the switch. Choose Circuits from the shortcut menu.
Step 2
Step 3
In the Circuits on Span dialog box, choose CLEAR to remove the switch. Click Apply.
Step 4
In the Confirm UPSR Switch dialog box, click Yes.
March 2003
A Force switch request on a span or card causes CTC to raise a FORCED-REQ condition. The
condition clears when you clear the Force switch; it is informational only.
Use this task to clear a path protection Force switch.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
NTP-B106 Remove a Path Protection Node
Cisco ONS 15327 Procedure Guide, R4.0
13-17