Dlp-B131 Search For Circuits - Cisco ONS 15327 Procedure Manual

Chapter 8 Manage Circuits
Click OK. Circuits matching the attributes in the Filter Circuits dialog box appear in the Circuits
Step 4
window.
To turn filtering off, click the Filter icon in the lower right corner of the Circuits window. Click the icon
Step 5
again to turn filtering on, and click the Filter button to change the filter attributes.
Return to your originating procedure (NTP).
Step 6

DLP-B131 Search for Circuits

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Navigate to the appropriate CTC view:
•
•
•
Click the Circuits tab.
Step 2
If you are in node or card view, choose the scope for the search in the Scope drop-down menu.
Step 3
Click Search.
Step 4
In the Circuit Name Search dialog box, complete the following:
Step 5
•
March 2003
Slot—Enter a slot number to filter circuits based on the source or destination slot; otherwise
–
leave the field blank.
Port—Enter a port number to filter circuits based on the source or destination port; otherwise
–
leave the field blank.
Type—Choose one: Any (type not used to filter circuits), STS (displays only STS circuits), VT
–
(displays only VT circuits), VT Tunnel (displays only VT tunnels), or VT Aggregation Point
(displays only VT aggregation points).
Size—Click the appropriate check boxes to filter circuits based on size: VT1.5, STS-1, STS3c,
–
STS-6c, STS-9c, STS-12c, STS-24c, STS-48c. The check boxes that appear depend on what you
entered in the Type field. If you chose Any, all sizes are available. If you chose VT, only VT1.5
is available. If you chose STS, only STS sizes are available, and if you chose VT Tunnel or VT
Aggregation Point, only STS-1 is available.
This task searches for an ONS 15327 circuit at the network, node, or card
level.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Retrieve or higher
To search the entire network, from the View menu choose Go to Network View.
To search for circuits that originate, terminate, or pass through a specific node, from the View menu
choose Go to Other Node, then choose the node you want to search and click OK.
To search for circuits that originate, terminate, or pass through a specific card, double-click the card
on the shelf graphic in node view to display the card in card view.
Find What—Enter the text of the circuit name you want to find.
NTP-B199 Locate and View Circuits
Cisco ONS 15327 Procedure Guide, R4.0
8-5