Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Ignition keys
1
Raising the Roll Bar
No Parts Required
Procedure
Raise the roll bar; refer to
21).
Description
No parts required
Cutting unit Installation Instructions
No parts required
No parts required
No parts required
No parts required
Production-year decal
Adjusting the Roll Bar (page
Qty.
–
1
–
–
–
–
1
Qty.
1
Review it before operating the machine.
1
Use it to reference engine information.
2
Start the engine.
2
Installing the Cutting Unit
Parts needed for this procedure:
1
Cutting unit Installation Instructions
Procedure
Install the cutting unit using the Installation Instructions
for that cutting unit.
12
Use
Raise the ROPS.
Install the cutting unit.
Adjust the left, front caster wheel.
Check the tire pressure.
Install weights.
Check the hydraulic fluid, engine oil,
and coolant levels.
Install the decal (CE Machines Only).
Use