D-Link DIR-878 User Manual page 149

DIR-878 AC1900 MU-MIMO Wi-Fi Gigabit Router
User Manual
To create a new tunnel, click the ADD button (
!
Setting for both devices which establish the tunnel should be the same.
Figure 119. The page for adding an IPsec tunnel. The General Settings section.
You can specify the following parameters:
Parameter
Dynamic IPsec
Remote host
Local identifier
Identifier value
Pre-shared key
General settings
Move the switch to the right to allow a remote host with any public IP
address to connect to the router via IPsec protocol. Such a setting can
be specified for one tunnel only. Connection requests via this tunnel
can be sent by a remote host only.
A remote subnet VPN gateway IP address. The field is available if the
Dynamic IPsec switch is moved to the left.
Select an identification method for the local host (router) from the
drop-down list:
Address: The local host is identified by its IP address.
FQDN: The local host is identified by its domain name. The value is
unavailable if the Main value is selected from the Exchange mode
list.
Specify the local host identifier.
A key for mutual authentication of the parties.
Page 149 of 191
Configuring via Web-based Interface
) in the Tunnels section.
Description