D-Link DIR-878 User Manual page 64

DIR-878 AC1900 MU-MIMO Wi-Fi Gigabit Router
Configuring via Web-based Interface
User Manual
Figure 51. The Connections Setup / WAN page. The advanced mode.
To create a new connection, click the ADD button ( ) in the Connections List section. Upon
that the connection creation page opens.
To edit an existing connection, in the Connections List section, left-click the relevant line in the
table. On the opened page, on the Basic tab, the mandatory settings of this WAN connection will
be displayed. To view all available settings of the WAN connection, go to the All Settings tab.
Change the needed parameters and click the APPLY button.
To disconnect a connection and establish it again, select the checkbox located to the left of the
relevant line in the table and click the RECONNECT button.
To remove a connection, in the Connections List section, select the checkbox located to the left
of the relevant line in the table and click the DELETE button ( ). Also you can remove a
connection on the editing page.
To allow multicast traffic (e.g. streaming video) for a connection, click the IGMP link (for the
description of the page, see the IGMP section, page 145).
To use one of existing WAN connections as the default IPv4 or IPv6 connection, in the Default
Gateway section, select the choice of the radio button which corresponds to this connection.
To return to the simplified mode, click the SIMPLIFIED MODE button (the button is unavailable if
several WAN connections are created).
Page 64 of 191