How To Use The Liquid Crystal Display (Lcd); How To Move Between The Various Displays; Monitoring Displays; Menu Displays - Hitachi NEXT Series Instruction Manual

3.3 How to Use the Liquid Crystal Display (LCD)

3.3.1 How to Move between the Various Displays

■ Monitoring Displays
There are three monitoring displays as shown
below. This monitoring display is the top screen.
The monitoring display switches ever y time the
MONITOR button is pressed.
■ Monitoring Display (
Monitor display 1
Monitor display 2
■ Message Display (
Monitor display 3
MONITOR
3. OPERATING PROCEDURE [How to Use the Liquid Crystal Display (LCD)]
3.3.2)
MONITOR
MONITOR
3.3.3)

■ Menu Displays

Follow the bottom line message on the display.
■ Menu Screen (
Function Menu Display
MENU
MONITOR
IMPORTANT
About the LCD Backlight
(1) In the event that no button has been used for 10
minutes, the LCD backlight automatically turns OFF for
protection to the display panel. It comes ON again if
any button is pressed, other than the START and STOP
buttons.
(2) If an event happens while the LCD backlight is off, the
backlight automatically turns ON and stays ON as long
as the event exists. Remote and instant stop mode
can't be set by the LCD monitor. Set after referring to
"3.4 How to Use the Digital Monitor."
■ Message Display
Automatic restart/stop messages after shutdown or
warning occurrence and inspection/maintenance
messages is preferentially displayed in the Monitor
Display 3.
By pressing the MONITOR button here, the display
can be switched but is back to the Monitor Display 3
after approximately 10 seconds.
3.3.5)
15