How To Use The Liquid Crystal Display (Lcd) - Hitachi NEXT Series Instruction Manual

3.3 How to Use the Liquid Crystal Display (LCD)

3.3.1 How to Move between the Various Displays
■ Monitoring Displays
There are three monitoring displays as shown below.
This monitoring display is the top screen
The monitoring display switches every time the
MONITOR button is pressed.
■ Monitor Screen (
Monitor display 1
Monitor display 2
■ Message Screen (
Monitor display 3
MONITOR
3. OPERATION PROCEDURE [How to Use the Liquid Crystal Display (LCD)]
3.3.2)
MONITOR
MONITOR
3.3.3)
■ Menu Displays
Follow the bottom line message on the display.
■ Menu Screen (
■ Function Menu display
MENU
MONITOR
IMPORTANT
About the LCD Backlight
(1) In the event that no button has been used for 10
minutes, the LCD backlight automatically turns OFF
for protection to the display panel. It comes ON
again if any button is pressed, other than the START
and STOP buttons.
(2) If an event happens while the LCD backlight is off,
the backlight automatically turns ON and stays ON
as long as the event exists. Remote and instant stop
mode can't be set by the LCD monitor. Set after
referring to "3.4 How to Use the Digital Monitor."
■ Message Display
Automatic restart/stop messages after shutdown or
warning occurrence and inspection/maintenance
messages is preferentially displayed in the Monitor
Display 3.
By pressing the MONITOR button here, the display
can be switched but is back to the Monitor Display 3
after approximately 10 seconds.
3.3.4)
15