Routing Options For Vlans; Overlapping (Tagged) Vlans - HP ProCurve 5300xl Series Management Manual

Advanced traffic

Hide thumbs Also See for ProCurve 5300xl Series:

Table of Contents

Protocol VLAN Environment. Figure 2-2 can also be applied to a protocol

VLAN environment. In this case, VLANs "W" and "X" represent routable

protocol VLANs. VLANs "Y" and "Z" can be any protocol VLAN. As noted for

the discussion of multiple port-based VLANs, VLAN 1 is not shown. Enabling

internal (IP) routing on the switch allows IP traffic to move between VLANs

on the switch. However, routable, non-IP traffic always requires an external

Routing Options for VLANs

Table 2-3. Options for Routing Between VLAN Types in the Switch

Requires an external router to route between VLANs.

Not a routable protocol type. End stations intended to receive traffic in these protocols must

be attached to the same physical network.

Protocol VLAN type not supported on the Series 3400cl and 6400cl switches.

A port can be a member of more than one VLAN of the same type if the device

to which the port connects complies with the 802.1Q VLAN standard. For

example, a port connected to a central server using a network interface card

(NIC) that complies with the 802.1Q standard can be a member of multiple

VLANs, allowing members of multiple VLANs to use the server. Although these

VLANs cannot communicate with each other through the server, they can all

access the server over the same connection from the switch. Where VLANs

IPX IPv4 IPv6 ARP Apple SNA

Static Virtual LANs (VLANs)

Static VLAN Operation

Show Quick Links

Table of Contents