Displaying Ospf Virtual Link Information - HP ProCurve 5300xl Series Management Manual

IP Routing Features
Configuring OSPF
HPswitch# show ip ospf virtual-link
OSPF Virtual Interface Status
Transit AreaID
--------------- --------------- --------------- ---------------
10.3.16.0
10.3.16.0
Figure 11-22.Example of Output for Show IP OSPF Virtual-Link
Table 11-14. CLI Display of OSPF Virtual Link Information
Field Description
Transit Area ID Area ID of transit area for the virtual link.
Neighbor Router Router ID of the virtual neighbor.
Authentication none or simple (same as for normal interface).
Interface State The state of the virtual link to the virtual neighbor. The possible values are:
• DOWN – the routing switch has not yet found a route to the virtual neighbor.
• P2P – (point-to-point) the routing switch has found a route to the virtual neighbor. Virtual links
11-66

Displaying OSPF Virtual Link Information

To display OSPF virtual link information, enter show ip ospf virtual-link at any
CLI level.
Neighbor Router Authentication
10.0.8.33
10.0.8.36
Syntax: show ip ospf virtual-link [area < area-id > | < ip-address >]
This display shows the following information.
are "virtual" serial links, hence the point-to-point terminology.
Notice from the syntax statement that you can get OSPF virtual link informa­
tion for a specific area or a specific IP address.
none
none
Interface State
P2P
P2P