Displaying Ospf External Link State Information - HP ProCurve 5300xl Series Management Manual

IP Routing Features
Configuring OSPF
HPswitch# show ip ospf external-link-state
Link State ID
--------------- --------------- ---- ----------- ----------
10.3.7.0
10.3.8.0
10.3.9.0
10.3.10.0
10.3.33.0
Figure 11-12.Example of Show IP OSPF External-Link-State Output
11-56

Displaying OSPF External Link State Information

To display external link state information, enter show ip ospf external-link-state
at any CLI level. When you enter this command, an output similar to the
following is displayed:
Router ID
10.0.8.37
10.0.8.37
10.0.8.37
10.0.8.37
10.0.8.36
Syntax: show ip ospf external-link-state
The OSPF external link state display shows the following information:
Table 11-8. CLI Display of OSPF External Link State Information
This Field... Displays...
Link State ID LSA ID for this LSA. Normally, the destination of the external route,
but may have some "host" bits set.
Router ID Router ID of the router that originated this external LSA.
Age Current age (in seconds) of this LSA.
Sequence # Sequence number of the current instance of this LSA.
Chksum(Hex) LSA checksum value.
Syntax: show ip ospf external-link-state [status | advertise] [link-state-id < link-state-
id > | router-id < router-id > | sequence-number < sequence# >]
The status keyword is optional and can be omitted. The output can be filtered
to show a subset of the total output by specifying the link-state-id, router-id, or
sequence-number options.
Age Sequence #
232 0x80000005
232 0x80000005
232 0x80000005
232 0x80000005
1098 0x800009cd
Checksum
0x0000d99f
0x0000cea9
0x0000c3b3
0x0000b8bd
0x0000b9dd