Siemens SIMEAS Q80 Operating Instruction page 114

E-38 SIMEAS Q80 7KG8080
10.2.5 Miscellaneous terminals and controls
10.2.5.1 Double row of LEDs
SIMEAS Q80 7KG8080 has a two rows of 3 LEDs apiece. The flashing of these LEDs indicates
which state is in effect. LEDs 3 and 4 are not affected at this time.
LED flashes
1
2
3
4
5
6
10.2.5.2 Status LED
10.2.5.3 LAN terminal
At the LAN terminal, SIMEAS Q80 7KG8080 is connected with the Ethernet and the PC. For
connection via a local network, an uncrossed Ethernet cable must be used, and for direct connection
of the measurement device to the PC, a crossed Ethernet cable is required.
10.2.5.4 GPS terminal
At the nine-pin GPS socket it is possible to connect a GPS-receiver of the type e.g. Garmin
GPS18LVC-5Hz, Meinberg GPS161AHSx (item number: 25150)or HOPF6875 (from firmware 7.0,
order number 7XV5664-0CA00). This enables absolute synchronization to GPS time. If the GPS-
receiver has reception, the measurement system synchronizes itself automatically. Find more
information about setup and configurations in section
NMEA sources are also supported. Therefore the clock must provide a 1s clock and the GPRMC string.
For the RS232-interface parameter see
Pin configuration of the DSUB9 connector.
Note
Power Quality Recorder SIMEAS Q80 7KG8080, Operating instruction
E50417-B1074-C419-A2, Release 09.02.2011
State
Measurement active
Trigger / event being recorded
no signal for synchronization
Frequency can not be measured
Free HD memory < 10MB (default value) or according to valid setting
System error
The STATUS LED indicates the device's current operating status. Right after the device is
activated, it flashes red a few times, then proceeds to flash green (during which the memory
card is checked for any available measurement task to start) and finally goes off, which is
indicative of normal operation..
· The max. cable length to the clock modules (HOPF or Meinberg) is 50 cm.
· The max. cable length to the Garmin GPS receiver is 9 m.
Synchronisation
here .
75
76
.
40