Cleaning The Drum - Toro CM-658H-S Operator's Manual

Cleaning the Drum

Important:
Do not strike on the drum with a
shovel, hammer, or any other device to loosen any
accumulated dried materials.
1. While the machine is running, use the handwheel
to tilt the drum slightly.
2. Engage the drum-tilt brake to prevent the drum
from tilting further and discharging the water.
3. As the drum is rotating, spray it thoroughly with
water before the material dries.
4. Allow the drum to rotate and tumble the loose
material and water, further loosening the rest of
the material.
5. Continue to spray the drum with water to remove
all material from the drum and mixing paddles.
6. When you have removed all material from
the surfaces of the drum and mixing paddles,
disengage the drum-tilt brake and use the
handwheel to tilt the drum and dump the water
from it.
7. If some material still remains in the drum, spray
the drum with water while it is tilted downward,
allowing the water and material to run out.
28