Servicing The Spark Plug - Toro CM-658H-S Operator's Manual

Servicing the Spark Plug

Service Interval: Every 100 hours/Every 6 months
(whichever comes first)—Check the
spark plug.
Every 300 hours/Yearly (whichever comes
first)—Replace the spark plug.
Spark Plug Specifications
Type: NGK BPR6ES or equivalent
Gap: 0.7 to 0.8 mm (0.028 to 0.031 inch)
Note:
Use a 21 mm (13/16 inch) spark-plug wrench
for removing and installing the spark plug.
Removing the Spark Plug
1. Park the machine on a level surface and shut
off the engine.
2. Ensure that the machine surfaces are cool.
3. Pull the spark-plug wire off the terminal of the
spark plug (Figure
Figure 46
1. Spark plug
4. Clean around the spark plug.
5. Rotate the spark plug counterclockwise using
a 21 mm (13/16 inch) spark-plug wrench to
remove the plug and the sealing washer
47).
46).
2. Wire
(Figure
Checking the Spark Plug
Important:
Do not clean the spark plug. Always
replace the spark plug when it has a black coating,
worn electrodes, an oily film, or cracks.
Note:
If you see light brown or gray on the insulator,
the engine is operating properly. A black coating on
the insulator usually means that the air cleaner is dirty.
Set the gap to 0.7 to 0.8 mm (0.028 to 0.031 inch).
g014506
34
Figure 47
Figure 48
g019749
g206628