Page 1
Commercial Use ET-MDNDP10 Model No. ENGLISH Thank you for purchasing this Panasonic product. ■ Before using this product, please read these “Operating Instructions” and the “Operating Instructions” of the projector carefully and save the manuals for future use. ■ Before using this product, be sure to read “Read this fi rst!” ( x page 3).
Contents Contents Read this first! Precautions for use Supported projector About the handling of the product Disposal Accessories Part names and functions Installing the Interface Board Before installing or removing the Interface Board How to install the Interface Board How to remove the Interface Board Specifications r Trademarks f DisplayPort™...
Failure to do so may cause electric shock. Importer’s name and address within the European Union Panasonic Marketing Europe GmbH Panasonic Testing Centre Winsbergring 15, 22525 Hamburg, Germany ENGLISH - 3...
Products other than the above may also be supported. Refer to the operating instructions for your projector or the Panasonic website (https://panasonic.net/cns/projector/). f If the main version of the firmware of the PT-RQ22K is less than 3.00, this interface board cannot be used.
Precautions for use Accessories Make sure that the following accessories are provided with your product. Numbers enclosed in < > show the number of accessories. Screw <4> (XSB3+8FN) Attention f Appropriately discard the packaging material after unpacking the product. f For missing accessories, consult your dealer. f Store small parts in an appropriate manner, and keep them away from small children.
Installing the Interface Board Installing the Interface Board It is recommended to ask a qualified technician to install or remove the Interface Board to a projector. A malfunction may occur due to static electricity. Consult your dealer. Before installing or removing the Interface Board f Always turn off the power of the projector before installing or removing the Interface Board.
Installing the Interface Board How to install the Interface Board Screws (4 locations) Salient Screws (4 locations) Slot cover Guide groove Fig. 1 Fig. 2 Fig. 3 Remove the slot cover. (Fig. 1) f Remove the four screws fixing the slot cover of the projector by rotating counterclockwise with a Phillips screwdriver.
Installing the Interface Board How to remove the Interface Board Handle Fig. 1 Remove the Interface Board. (Fig. 1) f Remove the four screws fixing the Interface Board by rotating counterclockwise with a Phillips screwdriver. The removed screws are used to fix the slot cover. f Hold the handle of the Interface Board and remove it slowly.
380 ] (13.4 ozs.) Note f “SLOT NX” is a name of the slot unique to Panasonic supporting the signal input for the 4K image. f The video signal that can actually display will vary depending on the projector that the Interface Board is installed.