At^smonc Cell Monitoring - Siemens TC37 Module At Command Reference

At command set cellular engines
Table of Contents

Advertisement

AT Command Set

6.17 AT^SMONC Cell Monitoring

Test command
Response
OK
AT^SMONC=?
Response
Execute command
^SMONC:
AT^SMONC
232,03,3010,4EAF,32,82,38,30,30,232,03,3010,0000,36,88,26,18,18,232,03,3
010,4EC3,32,112,23,15,15,232,03,3010,4BDA,34,90,17,9,9,232,03,3010,0000,
32,99,15,7,7,232,03,2010,00C0,35,113,9,1,1,232,03,3520,0000,32,85,8,0,0
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameter
The output contains 9 values from a maximum of 7 base stations. The first base
station is the serving cell.
Values for one base station in output order:
MCC
MNC
LAC
cell
BSIC
chann
RSSI
C1
C2
Note
Reference
· In dedicated mode, the parameters C1 and C2 cannot be updated, and
Siemens
· To some extent, the cell monitoring commands AT^MONI, AT^MONP and
TC3X_ATC_01_V04.00
Mobile country code, 3 decimal digits, e.g. 232
Value 000: not decoded
Mobile network code, 2 decimal digits, e.g. 03
Value 00: not decoded
Location area code, 4 hexadecimal digits, e.g. 3010
Value 0000: not decoded
Cell ID, 4 hexadecimal digits, e.g. 4EAF
Value 0000: not decoded
Base station identity code, 2 decimal digits, e.g. 32
ARFCN (Absolute Frequency Channel Number) of the BCCH
carrier, decimal, e.g. 82.
Value 0: not decoded. In this case, all remaining parameters related
to the same channel are neither decoded. For example, a non-
existing cell appears as follows: 000,00,0000,0000,00,0,0,0,0
Received signal level of the BCCH carrier, decimal value from
0 to 63.
The indicated value is composed of the measured value in dBm
plus an offset. This is in accordance with a formula specified in
3GPP TS 05.08.
Coefficient for base station reselection, decimal, e.g. 30
Coefficient for base station reselection, decimal, e.g. 30
therefore, should be ignored.
AT^SMONC cover the same parameters. The receiving level, for example,
can be queried with all three commands. Yet the resulting values may be
slightly different, even though obtained over a time period of a few seconds.
This is quite normal and nothing to worry about, as the cell information is
permanently updated.
See also Chapters 6.2 and 6.3
Page 161 of 204
29.05.2002

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tc35 moduleTc35 terminal

Table of Contents