Atz Set All Current Parameters To User Defined Profile; At&C Set Circuit Data Carrier Detect (Dcd) Function Mode - Siemens TC37 Module At Command Reference

AT Command Set

2.33 ATZ Set all current parameters to user defined profile

Execute command Response
ATZ[<value>] TA sets all current parameters to the user profile stored with AT&W (see Chapter
2.39 on page 37). If a connection is in progress, it will be terminated. The user
defined profile is stored to the non-volatile memory.
Note: If invalid, the user profile will be reset to the factory default profile. Any
additional commands on the same command line will be ignored. A delay of
300 ms is required before next command is sent, otherwise "OK" response may
be corrupted.
OK
Parameter
<value> 0 Reset to user profile
Reference Note
V.25ter
The GSM engines referred to in this manual can be assigned two profiles: the
factory profile (restored with AT&F) and the user profile (stored with AT&W). See
Chapter 2.36 for details on AT&F.
2.34 AT&C Set circuit Data Carrier Detect (DCD) function mode
Write command Response
AT&C[<value>]
This parameter determines how the state of circuit 109(DCD) relates to the
detection of received line signal from the distant end.
OK
Parameter
<value>
Reference Note
V.25ter Line state refers to RS-232 levels.
TC3X_ATC_01_V04.00
0 DCD line is always ON.
1 DCD line is ON in the presence of data carrier only.
Page 33 of 204 29.05.2002