Configuring Nms Login - HP A-F1000-E Getting Started Manual

Configuring NMS login

Connect the Ethernet port of the PC to the management Ethernet interface of the firewall module over an
IP network, as shown in
Figure 48 Network diagram for configuring NMS login
Follow these steps to configure SNMPv3 settings:
To do...
Enter system view
Enable SNMP agent
Configure an SNMP group
and specify its access right
Add a user to the SNMP group
Follow these steps to configure SNMPv1 and SNMPv2c settings:
To do...
Enter system view
Enable SNMP agent
Figure 48. Make sure the PC and the firewall module can reach each other.
Use the command...
system-view
snmp-agent
snmp-agent group v3 group-name
[ authentication | privacy ]
[ read-view read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
snmp-agent usm-user v3 user-name
group-name [ [ cipher ]
authentication-mode { md5 | sha }
auth-password ] [ acl acl-number ]
Use the command...
system-view
snmp-agent
70
Remarks
—
Optional
Disabled by default.
You can enable SNMP agent with this
command or any command that
begins with snmp-agent.
Required
By default, no SNMP group is
configured.
Required
If the cipher keyword is specified, both
auth-password and priv-password are
cipher text passwords.
Remarks
—
Optional
Disabled by default.
You can enable SNMP agent
with this command or any
command that begins with
snmp-agent.