Siemens SINUMERIK 840DE sl Manual page 67

If a static.ini of the TCU to be replaced (as of SW4.5) is found on the server, then the type of the
old TCU is preselected based on the HW ID found there. If this is not the case, the TCU20.2 type
is selected.
The following TCU types can be emulated:
● TCU
● TCU 20.2
● TCU 30.2
Note that if an older TCU is to be replaced by a TCU30.3, some interfaces cannot be used when
the HMI version is older than V4.7. The following interfaces are affected:
TCU to be replaced
TCU
TCU 20.2
TCU 30.2
Operator panel front: OP 015 black
Manual, 05/2019, A5E35227814B AB
Interfaces that cannot be used
X212, X213 (because they do not exist in the TCU)
X212 (because it does not exist in the TCU 20.2)
X211 (because it does not exist in the TCU 30.3)
Networking
5.4 Service and diagnostics
67