Siemens SIMATIC HMI Operating Instructions Manual page 62

Preface
Please observe notes labeled as follows:
Note
Notes contain important information concerning the product, its use or a specific section of
the documentation to which you should pay particular attention.
Registered trademarks
Names labeled with a ® symbol are registered trademarks of the Siemens AG. Other names
used in this documentation may be trademarks, the use of which by third parties for their
own purposes could violate the rights of the owner.
● HMI
● SIMATIC
● SIMATIC HMI
● SIMATIC ProTool
● SIMATIC WinCC
● SIMATIC WinCC flexible
● SIMATIC Industrial USB Hub 4
Representatives and offices
If you have any further questions relating to the products described in this manual, please
contact your local representative at the SIEMENS branch nearest you.
Your Siemens representative can be found at "http://www.siemens.com/automation/partner".
Training center
Siemens AG offers a variety of training courses in order to familiarize you with automation
systems. Please contact your regional training center, or our central training center in 90327
Nuremberg, Germany, for details.
Phone: +49 (911) 895-3200
Internet: "http://www.sitrain.com"
Technical support
You can find technical support for all A&D projects
Using the support request form on the web at:
"http://www.siemens.de/automation/support-request"
Phone: + 49 180 5050 222
Fax: + 49 180 5050 223
Further information about our technical support is available on the Internet at
"http://www.siemens.com/automation/service".
64
®
®
®
®
®
®
®
Operating Instructions, 09/2007, A5E00471973-02
Industrial USB Hub 4