Chapter 1 Installing Operating System
2.2
Before starting setup
The required preparation before the setup is described here.
2.2.1
Preparation for hardware
The location of components that are required for setup or confirmation is as shown in the figure below.
DISK ACCESS LED
Module POWER LED
1.
If the System POWER LED is on, shutdown the OS.
2.
Pull the power cords of both CPU/IO modules out of the outlets while the System POWER LED is
not lit.
12
Important
You can set up OS on the internal hard disk drive only. OS setup on the external
storage is not supported.
Install one hard disk
drive in this slot.
PRIMARY LED
FRONT
Express5800/R320e-E4, R320e-M4 Installation Guide (Linux)
CPU/IO module 0
System POWER LED
CPU/IO module 1
DUMP (NMI) switch
REAR
2. Setting up
POWER switch
AC inlet A
AC inlet B