Installing Ft Server Control Software - NEC Express Server Express5800 Series Installation Manual

Chapter 1 Installing Operating System
2.3.6

Installing ft Server Control Software

Follow the steps below to install ft Server Control Software.
1. Login the system with root user. If you login with graphical mode, select [Others...] to login.
2. Set the ft Server Control Software Install CD to optical disk drive. After a while, the drive will be
automatically mounted.
3. Run the following command to install ft Server Control Software.
# /run/media/root/FT1102052/ftsys/install.sh
4. The following message appears when installation completes. Press the <Enter> key to reboot the
system.
Enter YES to reboot now or NO to allow a manual reboot later: [YES]
5. Eject the ft Server Control Software Install CD from the optical disk drive.
6. After a while, system FT LED turns on. For details, see Chapter 1 (6.1 Error Messages by LED
Indication) in Maintenance Guide.
34
If the optical disk drive is not mounted automatically depending on your environment,
Tips
mount it on the desired location manually. If the mount destination differs, substitute it for
the actual destination appropriately.
Start up the multi-user target (text login mode) after reboot. If you temporarily use the
Tips
graphical target (graphical login mode) environment, execute the following command after
login.
# startx
The indication on screen may be corrupted when the system is shutdown or rebooted.
However, end processing is normally terminated.
Express5800/R320e-E4, R320e-M4 Installation Guide (Linux)
2. Setting up