Toshiba V Series Operation Manual page 32

Chapter 3 Setting
3
18
Each of the switches for EN751 and EN761 is described inTable 3-5.
Table 3-5 Operation Mode Setting Table (FN711)
Switch No. Name
1 M0 Operation mode
2 M1
3 TEST Test program
4 TAGL FROM tag load
5 DL Download
6 SEL Serial switching
7 DLSP DL speed
8 DBB Debug break
Operation Mode
• Normal: The EN7 module is operated in standard condition.
• Download: Used for downloading firmware to the EN7 module program ROM
(flash PROM). This mode is set in upgrading the firmware version.
• Test Program: Used for operating the test program. Never use this mode.
IP Address Type
• Class B (General): Used for connecting an Ethernet of integrated controllers or a
general Ethernet.
• TOSDIC-CIE 1200: Used for connecting a TOSDIC-CIE 1200 Ethernet. (The system
operates according to the data set in the flash PROM.)
• Setting from Tool: Used for operating the EN6 modules with the network
parameters set from the Engineering tool.
Function
M1 M0
off off
off on
on off
on on
on : Test mode,
off : Normal mode
on : Tag load from FROM,
off : Non-operation
on : Download mode,
off : Normal mode
on : TOOL=Tool Internal=Debug,
off : TOOL debug Internal=Tool
on : 115200BPS,
off : 57600BPS
Normally off
model 3000 Ethernet Module / DS Connection Module Operation Manual
Default
Setting (Before
shipment)
M1=off
Operation
M0=off
Normal
(Normal setting)
Reserve
Reserve
Memory clear
off
off
off
off
off
off