Steps
1. Align the screw holes on the rear camera circuit board with the screw holes on the tablet chassis.
2. Replace the three (M2x5) screws to secure the rear camera circuit board to the chassis.
Next steps
1. Install the
system
board.
2. Install the
coin-cell
battery.
3. Install the
front
camera.
4. Install the microphone.
5. Install the WWAN.
6. Install the WLAN.
7. Install the
solid-state
drive.
8. Install the
system
fan.
9. Install the heat-sink.
10. Install the
display
assembly.
11. Install the batteries.
12. Follow the procedure in
Micro serial port and power connector port
Removing micro serial port and power connector port
Prerequisites
1. Follow the procedure in
2. Remove the batteries.
3. Remove the
display
assembly.
About this task
The figure indicates the location of the micro serial port and power connector (DC-in) port and provides a visual representation of the
removal procedure.
54
Removing and installing components
after working inside your
tablet.
before working inside your
tablet.