Installing M.2 2230 Solid-State Drive; Installing The M.2 2280 Solid-State Drive - Dell Latitude 7220 Service Manual

Steps
1. Remove the (M2x3) screw that secures the solid-state drive to the system board.
2. Slide and remove the solid-state drive from the solid-state drive slot on the system board.

Installing M.2 2230 solid-state drive

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the installation
procedure:
Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2. Replace the screw (M2x3) that secures the solid-state drive module to the system board.
Next steps
1. Install the heat-sink.
2. Install the display assembly.
3. Install the batteries.
4. Follow the procedure in after working inside your tablet.

Installing the M.2 2280 solid-state drive

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components 31