Steps
1. For models shipped with an M.2 SSD door, remove the single screw (M2x2) that locks the SSD door release latch.
2. For models shipped with an M.2 SSD door, slide down and hold the SSD-door release latch and then remove the SSD door
from the tablet.
3. Slide the SSD release latch into the unlock position.
4. Remove the single screw (M2x3) that secures the solid-state drive assembly in place.
5. Pull the tab to remove the solid-state drive assembly from the tablet.
6. Flip the solid-state drive assembly and remove the single screw (M2x3) that secures the SSD cap to the SSD carrier.
7. Remove the SSD cap from the SSD carrier.
8. Remove the solid-state drive from the SSD carrier.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the
installation procedure:
Removing and installing components
29