Steps
NOTE:
For models shipped with an empty expansion bay at the top side of the tablet.
1. Align the screw holes on the blank top-cover with the screw holes on the tablet.
2. Replace the four screws (M2x5) to secure the blank top-cover to the tablet.
Next steps
1. Install the
back-cover
2. Install the batteries.
3. Install the
handle
(for models shipped with handle).
4. Install the stylus.
5. Follow the procedure in
USB daughter-board
Removing the USB daughter-board
Prerequisites
1. Follow the procedure in
2. Remove the stylus.
3. Remove the
handle
(for the models shipped with a handle).
4. Remove the batteries.
5. Remove the
back-cover
Steps
NOTE:
For models shipped with a USB connector in the expansion bay at the top side of the tablet.
1. Remove the two screws (M2x3) that secure the USB-FPC bracket to the system board.
2. Remove the USB-FPC bracket away from the tablet.
3. Disconnect the USB FPC from the connector on the USB daughter-board.
48
Removing and installing components
assembly.
after working inside your
before working inside your
assembly.
tablet.
tablet.