About this task
The figure indicates the location of the world-facing camera and provides a visual representation of the removal procedure.
Steps
NOTE:
For models shipped with a world-facing camera.
1. Align the screw holes on the world-facing camera with the screw holes on the tablet.
2. Replace the two screws (M2x3) to secure the world-facing camera to the tablet.
3. Connect the world-facing camera FPC to the connector on the system board.
4. Align the screw holes on the camera-connector bracket with the screw holes on the system board.
5. Replace the three screws (M2x3) to secure the camera-connector bracket to the system board.
6. Adhere the gasket on the top-left side of the system-board shielding cover.
Next steps
1. Install the
back-cover
2. Install the batteries.
3. Install the
handle
(for models shipped with handle).
4. Install the stylus.
assembly.
Removing and installing components
55