Steps
1. Disconnect the fan cable from the connector on the system board.
2. Unroute the fan cable from the routing guides along the right-side of the system-board shielding cover.
3. Remove the two screws (M2x5) that secure the fan to the tablet.
4. Remove the three screws (M2x2) that secure the SSD heat-sink to the system board.
5. Lift the fan with SSD heat-sink away from the tablet.
Installing the fan with SSD heat-sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the fan with SSD heat-sink and provides a visual representation of the installation procedure.
68
Removing and installing components