Rj45 Daughter-Board; Removing The Rj45 Daughter-Board - Dell Latitude 7230 Service Manual

Steps
NOTE: For models shipped with a Mini-serial RS232 connector in the expansion bay at the top side of the tablet.
1. Align the screw holes on the Mini-serial RS232 daughter-board with the screw holes on the system board.
2. Replace the two screws (M1x2.65) to secure the Mini-serial RS232 daughter-board to the system board.
3. Connect the Mini-serial RS232 FPC to the connector on the Mini-serial RS232 daughter-board.
4. Align the screw holes on the Mini-serial RS232 FPC bracket with the screw holes on the system board.
5. Replace the two screws (M2x3) to secure the Mini-serial RS232 FPC bracket to the system board.
Next steps
1. Install the back-cover
2. Install the batteries.
3. Install the handle (for models shipped with handle).
4. Install the stylus.
5. Follow the procedure in

RJ45 daughter-board

Removing the RJ45 daughter-board

Prerequisites
1. Follow the procedure in
2. Remove the stylus.
3. Remove the handle (for the models shipped with a handle).
4. Remove the batteries.
5. Remove the back-cover
About this task
The figure indicates the location of the RJ45 daughter-board and provides a visual representation of the removal procedure.
50 Removing and installing components
assembly.
after working inside your
before working inside your
assembly.
tablet.
tablet.