Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Phillips screwdriver #2
● Torx 8 screwdriver
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Handle
Back-cover assembly
M.2 solid-state drive
Wireless card
Screw type
M3.5x15
M2x3
M2.5x8 (Torx 8)
M2x5
M2x5
M2x3
M2x3
Quantity
2
2
19
1
1
1
1
Removing and installing components
Screw image
2
11