Table of Contents
Advertisement
Swap Channels
You can exchange the preset channel positons with this function. For
example, channel 1 exchanges positions with channel 122 by
conducting this operation.
1
Select a channel (e.g. channel 1) that you want to swap with the
remote control or the front control.
2
Press the DIGIT
button
(-/--)
screen, press the ALTERNATE
will appear.
3
Press the following buttons on the remote control to select each
channel position. (For 122, press "-/--" and then "2" button twice.)
0-99 position
···
100-199 position ···
200-255 position ···
4
The message "SWAPPING" will be displayed for 4 seconds and
then the channel swapping is completed. (e.g. position 1 and
122 are exchanged.)
Color System Selection
Direct Operation
When the clear picture cannot be obtained, select a Color system
among PAL, SECAM, NTSC4.43, and NTSC.
Press the C.SYS button on the remote control to change the Color
system until the optimum picture is obtained.
NOTE:
Initial setting of the Color system is AUTO. Normally set the Color system to AUTO.
The selected Color system with the C.SYS button on the remote control is not memorized.
You can memorize the Color system setting with the Menu operation. (p30)
. While the "- -" is displayed on the
(
)
p
button. The Channel Swap display
0-99
(-/--)
00-99
(-/--)
(-/--)
00-55
Channel Swap display
C.SYS button
AUTO
PAL
SECAM
NTSC4.43
NTSC
Remote Control
OK
ON
TIMER
AUDIO-S VIDEO-S S.SYS C.SYS
LAMP
SCREEN AUTO PC FREEZE
MODE
TV Operation
C.SYS button
29
Advertisement
Table of Contents
