Epson L-300 User Manual page 11

□ Beware of electrical shock hazards.
□ Do not use this product near water or handle it with wet hands.
□ Keep away from heat sources. Do not use the charger outside the temperature range of
5° C to 35° C (41° F to 95° F).
□ Do not insert objects into any openings as they may touch dangerous voltage points or
short out parts.
□ Never disassemble or modify this product.
□ Use only indoors, in a dry location.
□ Do not expose to water or excess humidity.
□ Use the type of power source indicated on the label, and always supply power directly
from a standard domestic electrical outlet.
□ Do not place multiple loads on the electrical outlet.
□ Be sure your AC power cord meets the relevant local safety standards.
□ Never insert or disconnect the power plug with wet hands.
□ Power-supply cords should be protected from abrasion, cuts, crimping and kinking. Be
sure to place your cords to avoid any damage. Do not place objects on top of the power
cord or allow the power cord to be stepped on or run over. You should take special care
to try to keep the power cord straight at the ends and the points where it enters and
leaves the transformer.
□ Do not allow the AC power cord to become damaged or frayed.
□ Unplug your equipment from the wall outlet and refer servicing to qualified personnel
under the following conditions:
If the power cord or plug is damaged; if liquid has entered your equipment; if your
equipment has been exposed to rain or water; if your equipment has been dropped
or damaged; if your equipment is operating abnormally or exhibits a distinct change in
performance. Adjust only those controls described in your product documentation.
□ Never attempt to repair this product yourself. Improper repair work can be dangerous.
□ Unplug this product from the wall outlet before cleaning.
□ Clean only with a clean, soft dry cloth.
□ Do not use liquid or aerosol cleaners.
□ Keep out of reach of children.
□ For US and Canadian users:
Use the included power cord or a 6-10 foot UL-approved type SPT-2 or heavier type,
2 x 18 AWG cord with a 125 V 10 A plug and 125V 7A connector.
□ If you plan to use the AC Adapter in Germany, observe the following:
To provide adequate short-circuit protection and over-current protection for these
products, the building installation must be protected by a 16 Amp circuit breaker.
This product is designed for use with EPSON products ONLY.
Do not attempt to use it with other electronic devices.
9