Epson L-300 User Manual page 98

THERE IS NO PLAYBACK IMAGE ON THE LCD MONITOR.
Did you turn the DIAL SWITCH completely?
Turn the DIAL SWITCH carefully to PLAYBACK. Be sure to turn press the POWER button fully
(See page 22.)
Is Power Saving turned on?
Turn off the Power Save function. (See page 82.)
Is the camera connected to a TV?
When the camera is operating on batteries only while connected to TV, the LCD monitor is
disabled.
Is the camera connected to a computer?
When the camera is connected to a computer, the LCD monitor is disabled.
AFTER TAKING A PHOTO THROUGH THE LCD MONITOR THE DISPLAY PANEL DISAPPEARS.
Is Power Saving turned on?
If the power saving interval is set at 1 minute, it may simply be that the power saving is
working properly. You can extend the time it takes before going into sleep status.
You can also turn it off. (See page 82.)
Are your batteries strong enough?
When the batteries are low, the LCD monitor will turn off briefly while the camera recycles for
the next shot.
THE LCD MONITOR IS HARD TO SEE.
Have you tried adjusting the LCD monitor brightness level?
Adjust the "LCD Brightness" control. (See page 84.)
THE LCD MONITOR DISPLAYS VERTICAL LINES.
Did you point the camera toward very bright light?
When you use the LCD monitor to take photos, any very bright light may affect the CCD and
cause the lines to appear on your screen. They will NOT appear in the recorded image itself.
NO IMAGE APPEARS ON THE TV SCREEN WHEN THE CAMERA IS CONNECTED.
Is the power switched on?
See [Camera power won't turn on] on page 94 and check the camera.
96