BATTERIES AND MEMORY CARD INSTALLATION
ACCESSING THE BATTERIES AND MEMORY CARD
Be sure the camera
is turned OFF before
opening and closing
the battery / memory
card cover.
HOW TO INSERT AND REMOVE THE MEMORY CARD
The memory card is installed in the camera at the factory. Check that it is
properly set.
The memory card is a precision electronic component. Comply with
the instructions below to avoid damage.
・Don't touch the terminals with your fingers or metal. Resulting static
electricity could cause damage. Discharge body static electricity by
touching something metal before you handle the card.
・Don't bend, drop or otherwise shock the memory card.
・Keep the memory card away from water, excessive heat or direct
sunlight.
・Don't break down or take apart the memory card.
The memory card must be removed when:
・ you would like to copy images saved on the memory card to a computer.
・ the printer has a memory card slot that you may use directly.
16
Opening the cover
Slide the Battery / Memory Card
Cover in the direction of the
arrow while pressing down on it.
MEMORY CARD INSERTION
Checking that the card is facing the right
direction, slide it in until it clicks.
REMOVING THE MEMORY CARD
Release the card by pushing once and then pull
it out with your fingers. (Push once to set it,
push again to release it. )
Closing the cover
Slide the Battery / Memory Card
Cover in the direction of the
arrow until in clicks into place.
You may also use
a MultiMedia Card
You may use an SD
memory card or a
MultiMedia Card. (See
pages 29, 90-92.)