Toro EVOLUTION Series Manual page 13

To replace the battery:
1. The battery is stored in the upper half of the sensor
housing. To access the battery, release and remove the
upper housing by twisting it clockwise and lifting the
upper housing off of the lower half..
2. Disconnect the battery wire clip. Remove and replace the
used battery with a fresh 9V Alkaline battery. Reconnect
the battery wire clip.
3. To reassemble the sensor housing, thread the antenna wire
through the lower housing, exiting the center hole in the
bottom grid.
4. Mate the two halves squarely, aligning the translucent
dome above the mounting bracket.
5. Turn the upper housing counterclockwise to securely
engage the lower housing.
To clear a weak battery alert condition
1. At the controller, press
On ALERTS, press
2.
3. On the Alerts screen, press
LOW WS BATTERY alert. Press
ALERTS
CLEAR ALL
LOW WS BATTERY
4. You will be prompted to CLEAR ALERT?
to change to YES. Press
Press
.
.
to move to the
.
.
13