Encoder Streams - Bosch MIC IP fusion 9000i Operation Manual

MIC IP fusion 9000i
To obtain the highest quality at the lowest bandwidth, even in the case of increased
movement in the picture, configure the quality settings as follows:
1.
2.
3.
Background delta QP
Select the appropriate encoding quality level for a background region defined in Encoder
Regions. The lower the QP value, the higher the encoding quality.
Object delta QP
Select the appropriate encoding quality level for an object region defined in Encoder Regions.
The lower the QP value, the higher the encoding quality.
Default
Click Default to return the profile to the factory default values.
5.3

Encoder Streams

Note: If you access this menu while the camera is recording, the following message appears at
the top of the page:
Recording is currently active. Therefore, for 'Current profile' the respective stream profile
selected for recording is displayed for information.
When you access the Encoder Streams menu, the left tab (Video 1) is selected. The Video 1
tab displays the Encoder Streams options for the visible camera.
To configure Encoder Streams options for the thermal camera, select the right tab (Video 2 /
Camera 2).
Property
Select one of the resolutions for each stream.
Note: In order to select the option "720p (1 MP)" here, you must first set the field Sensor
mode in Camera > Installer Menu to "60 fps."
The table below identifies the options available in the field Property for Stream 1 and the
available options in the field Property for Stream 2, depending on the options selected for
Stream 1.
Stream 2
(recording)
720p (1 MP)
1080p (2 MP)
Bosch Security Systems
Observe the coverage area during normal movement in the preview images.
Set the value for Min. P-frame QP to the highest value at which the image quality still
meets your needs.
Set the value for I/P-frame delta QP to the lowest possible value. This is how to save
bandwidth and memory in normal scenes. The image quality is retained even in the case
of increased movement since the bandwidth is then filled up to the value that is entered
under Maximum bit rate.
720p (1 MP)
1080p (2 MP)
Option selected for Stream 1
(recording)
Options
Options for Stream 2 (recording)
720p (1 MP)
SD
D1 4:3 (cropped)
640x480
1080p (2 MP)
Operation Manual
Camera | en 27
2019-11 | 1.2 |