Network; Network Services; Network Access - Bosch MIC IP fusion 9000i Operation Manual

MIC IP fusion 9000i
8

Network

8.1

Network Services

This page shows an overview of all available network services. Use the checkbox to activate or
deactivate a network service. Click on the settings symbol next to the network service to go to
the settings page for this network service.
Select the appropriate network services from the list on the page:
–
–
–
–
–
–
–
–
–
–
–
–
–
–
8.2

Network Access

The settings on this page are used to integrate the camera into an existing network.
Automatic IPv4 assignment
If the network has a DHCP server for the dynamic assignment of IP addresses, select On or On
plus Link-Local to automatically accept the DHCP-assigned IP address.
If no DHCP server is available select On plus Link-Local to automatically assign a Link-Local
(Auto-IP) address.
For certain applications, the DHCP server must support the fixed assignment between IP
address and MAC address, and must be appropriately set up so that, once an IP address is
assigned, it is retained each time the system is rebooted.
IPv4
Fill in the 3 fields in this section of the screen.
IP address
Enter the desired IP address for the camera in this field. The IP address must be valid for the
network.
Subnet mask
Enter the appropriate subnet mask for the selected IP address here.
Gateway address
If you want the unit to establish a connection to a remote location in a different subnet, enter
the IP address of the gateway here. Otherwise leave the box blank (0.0.0.0).
IPv6
Consult with the network administrator before making changes to this section.
IP address
Enter the desired IP address for the camera in this field. The IP address must be valid for the
network. A typical IPv6 address may resemble the following example:
2001:db8: :52:1:1
Bosch Security Systems
HTTP
HTTPS
RSTP
RCP
FTP
SNMP
iSCSI
UPnP
NTP server
Discovery
ONVIF discovery
GB/T 28181
Password reset mechanism
Ping response
Operation Manual
Network | en 51
2019-11 | 1.2 |