Manually Adding And Deleting Channels In The Channel Memory - Toshiba 42HPX95 Owner's Manual

Programming channels into the TV's channel memory
Manually adding and deleting channels in
the channel memory
After automatically programming channels into the channel
memory, you can manually add or delete individual channels.
To add or delete channels in the channel memory:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3).
Setup
Installation
Sleep Timer
On/Off Timer
PC Settings
HDMI 1 Audio Auto
HDMI 2 Audio Auto
Slide Show Interval 2 Sec
Navigate Select CH RTN Back
3. Open the Terrestrial menu, highlight Channel Add/Delete,
and then press ENTER.
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
Navigate Back
Select CH RTN
4. The illustration below left shows channels programmed for
the ANT 1 antenna input. To view the list of channels
programmed for the ANT 2 or Cable box antenna input,
press the y z buttons to highlight either "ANT 2" or
"Cable Box" and press ENTER.
Note: "Cable Box" will appear only if you connected a cable
box to your TV.
Channel Add/Delete
2 Analog
2 - 1 Digital
2 - 2 Digital
Analog
3
Analog
4
5 Analog
6 Analog
7 Analog
7 - 1 Digital
8 Analog
48
#01E_046-048_4250HPX95 48
Black
(E) 42/50HPX95 *web 213:276
Chapter 6: Setting up your TV
EXIT Exit
Exit
EXIT
Channel Add/Delete
ANT 1 Cable Box
ANT 1 1 Analog ANT 1
ANT 2 2 Analog ANT 2
Cable Box 3 Analog Cable Box
Analog
4
Analog
5
Analog
6
7 Analog
Reset 8 Analog Reset
Cancel 9 Analog Cancel
Done 10 Analog Done
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(continued)
To add a channel to the channel memory:
Highlight the unchecked box next to the channel number
you want to add, and then press ENTER to check the box.
To manually add digital subchannels on a physical channel:
Use the Channel Numbers and the Dash (–/100) on the
remote control to enter the channel number (for example,
56–1).
If the channel is found, the number will be added to the list
and the box will be checked.
If the channel is not found, a message will appear.
To remove a channel from the channel memory:
Highlight the checked box next to the channel number you
want to remove, and then press ENTER to uncheck the
box.
To save your new settings:
Highlight Done and press ENTER.
To revert to your original settings:
Highlight Cancel and press ENTER before saving.
To remove all channels from the channel memory:
Highlight Reset and press ENTER, and then highlight
Done and press ENTER.
Note:
• This action applies to the current antenna input only. To
delete/add channels on the other input, highlight the input
you want (ANT1 or ANT 2) and press ENTER.
• This action cannot be canceled unless you highlight Cancel
and press ENTER before saving your changes.
Channel Add/Delete
Analog
2
2 - 1 Digital
2 - 2 Digital
3 Analog
4 Analog
Digital
5
Analog
6
7 Analog
7 - 1 Digital
Analog
8
05.9.12, 10:19 PM
ANT 1
ANT 1
ANT 2
Cable Box
Reset
Cancel
Done