Connecting A Vcr And Satellite Receiver - Toshiba 50HPX95 Owner's Manual

Connecting a VCR and satellite receiver

You will need:
one signal splitter
four coaxial cables
one set of component video cables (if your satellite receiver
does not have component video, connect the standard A/V
cables only)
one pair of standard audio cables
three sets of standard A/V cables
• For better picture performance, if your satellite receiver and VCR
have S-video, connect S-video cables (plus the audio cables)
instead of the standard video cables. Do not connect both types of
video cables to VIDEO 1 (or VIDEO 2) at the same time or the
picture performance will be unacceptable.
• If you have a mono VCR, connect L/MONO on the TV (VIDEO 1)
to your VCR's audio out terminal using the white audio cable only.
To view satellite programs using the component video
connections:
Select the ColorStream HD-1 video input source on the
TV.*
To view satellite programs using the standard
video connections or to record satellite programs:
Turn on all three devices. Set the VCR to the appropriate
line input (refer to your VCR owner's manual for details).
Select the VIDEO 2 video input source on the TV.*
To view the VCR or view and record antenna channels:
Turn ON the VCR. Tune the VCR to the channel you want
to watch. Select the VIDEO 1 video input source on the
TV.*
_____________
*
To select the video input source, press INPUT on the remote control
(see page 72). To program the TV remote control to operate other
devices, see Chapter 3.
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
18
Chapter 2: Connecting your TV
Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1,
ANT 2, VIDEO 1, VIDEO 2, and VIDEO 3 terminals when the appropriate
input mode is selected.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
From antenna
IN
Signal splitter
OUT OUT
Stereo VCR
IN from ANT
CH 3
CH 4
OUT to TV
TV back panel
From satellite dish
Y
P P
B R
Satellite
IN
S-VIDEO COMPONENT VIDEO VIDEO
OUT
To enable the TV Guide On Screen
1. Connect the G-LINK ™ cable according to the
instructions on page 28.
2. Make sure the VCR is connected to the A/V OUT
terminals on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your
VCR owner's manual for details), and then turn OFF the
VCR.
4. See Chapter 5 for details on setting up the TV Guide
™
On Screen system.
5. See Chapter 7 for details on using the TV Guide
™
On Screen system.
Note: The TV Guide On Screen™ system does not receive program
listings from or for any satellite service.
VIDEO AUDIO
L R
IN
OUT
L R
Satellite receiver
AUDIO
OUT
L L
R R
OUT
™ recording features: