Scrolling The Theaterwide ® Picture; Using The Auto Aspect Ratio Feature - Toshiba 50HPX95 Owner's Manual

Scrolling the TheaterWide
(TheaterWide 2 and 3 only)
You can set separate scroll settings for TheaterWide 2 and
TheaterWide 3 modes for each input.
To set the scroll settings:
1. Press INPUT on the remote control or TV/VIDEO on the
TV to select the input for which you want to set the picture
size and scroll settings.
2. Press MENU and open the Video menu.
3. Highlight Theater Settings and press ENTER.
Video
Picture Settings
Advanced Picture Settings
Theater Settings
Navigate Select CH RTN Back EXIT
4. In the Picture Size field, select either TheaterWide 2 or
TheaterWide 3 (you cannot scroll in any other mode).
5. Press z to highlight the Picture Scroll field.
6. Press x or • to scroll the picture up and down as needed,
from –10 to +20.
Theater Settings
Picture Size
Picture Scroll 0
Cinema Mode
Auto Aspect Ratio
Reset
7. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
NOTICE OF POSSIBLE ADVERSE
EFFECTS ON PLASMA DISPLAY
Avoid displaying stationary images on your
Plasma display for extended periods of
time. Fixed (non-moving) images
(including, but not limited to, PIP/POP
windows, closed captions, video game
patterns, TV station logos, stock tickers,
and websites) and special formats that do
not use the entire screen, can become
permanently ingrained in the Plasma
display and cause subtle, but permanent,
ghost images. This type of damage is
NOT COVERED BY YOUR WARRANTY.
See pages 4 and 5 for details.
Chapter 8: Using the TV's features
®
picture
Exit
TheaterWide 3
Film
On
Done
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

Using the auto aspect ratio feature

When the auto aspect ratio feature is set to On, the picture size
is automatically selected when one of the following input
sources is received:
• A 480i signal from the VIDEO 1, VIDEO 2, VIDEO 3,
ColorStream HD-1, or ColorStream HD-2 input.
• A 1080i, 480i, 480p, or 720p signal from the HDMI input.
Aspect ratio
of signal source
4:3 normal
4:3 letter box
16:9 full
Not defined
(no ID-1 data or )
HDMI aspect data)
Note:
• The auto aspect ratio feature is not applicable to antenna or Cable input
sources.
• The auto aspect ratio feature is not available when the POP double-
window is open, the Freeze mode is active, or the TV Guide On Screen™
system is open.
To turn on the auto aspect ratio feature:
1. Press MENU and open the Video menu.
2. Highlight Theater Settings and press ENTER.
Video
Picture Settings
Advanced Picture Settings
Theater Settings
Navigate Select CH RTN Back EXIT
3. In the Auto Aspect Ratio field, select On.
Theater Settings
Picture Size
Picture Scroll -1
Cinema Mode
Auto Aspect Ratio
Reset
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
To turn off the auto aspect ratio feature:
Select Off in step 3 above.
Automatic aspect size
(automatically selected
when Auto Aspect is On)
Natural (with sidebars)
TheaterWide 2
Full
User-selected picture size
(see pages 77–78)
Exit
Natural
Film
On
Done
79