Model VNT-PS Power Supply for VNT INTRODUCTION The Model VNT-PS is used to isolate the ground of the VNT (Virtual Network Tunnel) from the FireFinder-XLS system ground. INSTALLATION Remove all system power before installation, first battery then AC. (To power up, connect the AC first, then the battery.)
Page 2
NON-POWER LIMITED THE ENCLOSURE THE ENCLOSURE Figure 3 Typical VNT-PS Wiring to VNT ELECTRICAL RATINGS Special Application: The VNT-PS may only be used to connect PSC-12 (P/N 500- 033340) and VNT (P/N 500-650490). Output Voltage: 24VDC Output Current: 1.7A max...