ABB SM2000 Compact Flash Hardware Installation page 3

...3 Fitting Media Board
Sub-Assembly – Figs. 3.1 to 3.5
5) Check the position of PCB link LK1 – see Fig. 3.4.
5V Position
SmartMedia
6) Fit the new media board sub-assembly – see Fig. 3.3.
7) Refit the PCB locking bar and chassis top cover –
see Fig. 3.5.
Refit PCB locking bar
1
ensuring the slots
in the bar locate correctly
on the boards and chassis
8) Refit the instrument to the case – see Fig. 3.1.
9) Restore the power supply to the instrument.
LK1
Fig. 3.4 PCB Link LK1 Positions
Caution. When positioning the
chassis top cover, take care not to
damage the EMC contacts.
5
Fig. 3.5 Refitting the PCB Locking Bar and Chassis Top Cover
1
EMC Contacts
Slide forward
LK1
3.3V Position
Compact Flash
Check that PCB link LK1
is fitted and is in the
correct position for
Compact Flash hardware.
Refit pozidriv screws
5
(one each side)
3
2 Position top cover as shown
Lower rear
4
3