Installation Procedure - HP 12500 Series Installation Manual

IMPORTANT:
Make sure no filler panel or card is installed on the front panel of the switch before you remove or
•
install a lower cable management bracket.
• Keep the removed chassis panel and cable management brackets for future use.

Installation procedure

Each 12500 switch has keyhole standoffs on its cable management bracket and keyholes on the chassis
for attaching the cable management bracket to the chassis. See
Figure 27 Keyhole standoff and keyhole
(1) Keyhole standoff
Installing an upper expansion cable management bracket
Holding the notches on both sides of the chassis panel above the upper cable management
1.
bracket, gently remove the panel.
Pressing the two sides of the front panel, pivot the power frame front panel upward.
2.
Loosen the fastening screws on the upper cable management bracket with a Phillips screwdriver.
3.
Align the keyhole standoffs on the rear of the cable management bracket with the keyholes on the
4.
chassis and remove the cable management bracket.
Align the keyhole standoffs on the upper expansion cable management bracket (with a mark) with
5.
the keyholes on the chassis.
Push the expansion cable management bracket forward until it makes close contact with the chassis.
6.
Then pull the expansion cable management bracket downwards a little until the keyhole standoff fits
into the keyhole on the chassis.
Unpack the screws come with the expansion cable management bracket and fasten them with a
7.
Phillips screwdriver to attach the expansion cable management bracket to the chassis.
Close the power frame front panel.
8.
Figure
(2) Keyhole
29
27.