Configuring Temperature Thresholds For A Card - HP 12500 Series Installation Manual

Line-card power status:
Slot
----
2
3
4
5
6
7
8
9

Configuring temperature thresholds for a card

You can set temperature thresholds for a card. When the temperature reaches the threshold, the switch
generates alarms.
Configuring temperature thresholds for a card
Step
1. Enter system view.
2. Configure temperature alarm
thresholds for a card.
Displaying the temperature information on your switch
Use the display environment command to display the temperature information of the sensors on the cards,
including the current temperature and temperature thresholds.
# Display the temperature information of the cards on the switch.
<Sysname> display environment
In standalone mode:
•
System temperature information (degree centigrade):
-------------------------------------------------------------------------------
Slot
1
1
1
5
5
5
Board-Type Watts
--------------- -----
None --
None --
None --
LST1GT48LEC1 190
None --
None --
None --
None --
Sensor Temperature
inflow 1 21
outflow 1 24
hotspot 1 27
inflow 1 27
outflow 1 27
hotspot 1 30
Status
------
Absent
Absent
Absent
On
Absent
Absent
Absent
Absent
Command
system-view
•
In standalone mode:
temperature-limit slot slot-number { inflow | hotspot | outflow }
sensor-num lowerlimit warninglimit [ alarmlimit ]
•
In IRF mode:
temperature-limit chassis chassis-number slot slot-number { inflow |
hotspot | outflow } sensor-num lowerlimit warninglimit [ alarmlimit ]
LowerLimit WarningLimit
-25
-15
-15
-20
0
-10
67
AlarmLimit ShutdownLimit
70 80
70 85
75 85
65 85
70 85
70 80
N/A
N/A
N/A
N/A
N/A
N/A